Ductwork and ventilation, fitted to the building
Measured on site, sealed as it goes in, balanced before handover
New duct runs, replacement work and ventilation systems for homes and small commercial premises — set out to the space they are going into.
Set out to the space
Runs are marked to the building in front of us, not scaled off a drawing.
Joint by joint
Joints, connections and hangers fixed and sealed as the run goes in.
Measured at the terminals
Airflow checked at each terminal and adjusted before we leave.
Priced from the survey, not from a list
We quote after seeing the space: the route it allows, the duct sizes it needs and the components that actually go in. Nothing is added without it being agreed with you first.
Component rates are published, so you can see how a figure is built up before anyone visits.
Three ways most jobs begin
Most enquiries fall into one of these. If yours spans two of them, we will say so at survey and quote it as one job.
New installations
Complete ductwork and ventilation systems for fit-outs, extensions and new layouts, taken from first fix to a balanced system.
Replacement
Duct runs that have had their day removed and rebuilt to the same line, with the host unit checked once they are reconnected.
Ventilation systems
Supply and extract systems with their plant connections and air terminals, run up and set as a single system.
Before handover
Nothing is signed off until the airflow has been measured at every terminal and the dampers set to match.
If a route has to change once work has started, we agree the change with you before anything is cut.
Set out on site. Sealed as it goes in. Balanced before handover.
Straight duct runs
Galvanised duct and fittings installed to the route the space allows.
Bends & fittings
Changes of direction and transitions made to suit the structure on site.
Dampers
Volume control fitted where a branch has to be set after balancing.
Vents & grilles
Supply and extract terminals set level, sealed and secured.
Silencers & plant connections
Rigid and flexible connections made to the plant, sealed and supported.
Rates shown are typical component ranges. The final figure follows the route, the duct sizes and the components a site actually needs — confirmed from a survey before any work starts.
Send us the space, we will quote the work
Drawings help but are not essential. Book a survey and the route gets set out on site, then the project is priced from what is actually needed.
